1.
Q: Does Blower package in wood box still damage easily? A: Mostly not, otherwise hit against something hard during the shipping will cause the wood box be damaged 2. Q: Sometimes, when we receive the blower with painting off at motor and blower connect part, what the reason is? A: Before the painting process, the oil or dust on the surface didn’t fully clean 3. Q: The motor burn off or damage by something go inside? Where is the problem? A: it may suck in above of motor, there is a wire box, sometimes go inside under the box 4. Q: what the motor with insulated finish, and why something go inside the blower, and it still burning? A: Yes, it is insulated, but when the blower turn on, the dust or something hard be magnetic pulled on the wire, during the shake, shock scrub the wire, cause the painting off, will easily burned by short 5. Q: Why the blower sometimes with noise? A: Possible the fan scrub the housing or cover, the other reason may bearing damage 6. Q: Why something be sucked inside the blower will cause the motor burning? A: It will cause the fan cannot work, and then motor over charge will let the temp raising fast, finally burning 7. Q: Why the current is different on same model? A: This is normal, but the small type is different a little bit, the big type is different more, sometimes the reason is voltage 8. Q: Why the start up current of single phase is higher than three phase one? A: Our blower screw by human, if screw tight, the start up current will be higher, and this is direct proportion with power 9. Q: How to avoid if our customers ask Emore Horn the quote directly? A: We can remark some No. or alphabet in back of our model No., and the other distributor or your customer ask us the quote with that model No. next time, we will know it and inform to you 10. Q: If our customers ask Emore Horn the price of air tight model, what the Emore Horn can do for distributor? A: We will reply to your customers what the price of air tight model will be pretty higher, because this is custom-made 11. Q: what means the model No. with L, LS or LF? A: L: Waterproof, LS: Waterproof with plating finish. LF: Waterproof with Teflon 12. Q: We need the blower which cannot happen the oil run out, what the model we need to use? A: You need to use the model No. mark with LS back 13. Q: We need the blower with anti-corrosion, what the model we need to use? A: You need to use the model No. mark with LF back 14. Q: Can model 329 use for high temperature? What the highest temperature at in and out? A: The model 329L use on usual temperature which the inner can use for 150℃, the outer can be 160℃, the model 329 cannot use for such high temperature 15. Q: Do we ask the blower mark with own brand? A: Actually not, otherwise this is use themselves, and the quantity is higher than 50 pcs/model. 16. Q: Can you service with on site repair? A: We don’t offer this service, please send the damage blower to our factory for repair. 17. Q: Who will in charge of the repair cost if this is happening during the shipping? A: Please check if the outer box damage seriously, you can reject it, if you confirm it, we will not in charge of any cost 18. Q: The pressure of model 529 with 50HZ motor is 220mbar, why use the motor 60HZ is only 200mbar? A: Because the volume is 6.2 m3/min with 60HZ motor, 5.2 m3/min with 50HZ motor, if the motor is same power, the higher volume reversly the pressure will be lower 19. Q: Do we use the pressure relief valve adjust the air volumn? A: No, need to adjust with another valve 20. Q: How much DB lower if we assemble the silencer? A: It can be lower 10 DB |